# Differences

This shows you the differences between two versions of the page.

 calculate_wind_field_for_10_sec [2012/08/10 22:40]marenlie created calculate_wind_field_for_10_sec [2017/11/10 09:09] (current) 2012/08/11 13:10 marenlie [The wind field change is still above 10% after 10 sec] 2012/08/10 22:40 marenlie created Next revision Previous revision 2012/08/11 13:10 marenlie [The wind field change is still above 10% after 10 sec] 2012/08/10 22:40 marenlie created Line 10: Line 10: As ENVI-met remarks, you should increase the border grids, if the problem is at //one of the borders//. \\ As ENVI-met remarks, you should increase the border grids, if the problem is at //one of the borders//. \\ If the problem is //between a high building and the model top//, you should increase the total model height. \\ If the problem is //between a high building and the model top//, you should increase the total model height. \\ - In case you have very tall buildings in your model and do not want to change the model area you can tell ENVI-met to clip buildings at a certain height. To do so go to the [[Advanced Settings Panel]] and change the value for "​**Maximum allowed Building Height**"​ \\ + In case you have very tall buildings in your model and do not want to change the model area you can tell ENVI-met to clip buildings at a certain height. To do so go to the [[advanced settings|Advanced Settings Panel]] and change the value for "​**Maximum allowed Building Height**"​ \\ The problem might also be //inside// the model are, where those modifications do not help (e.g. due to a jet effect between two buildings or at a corner). \\ The problem might also be //inside// the model are, where those modifications do not help (e.g. due to a jet effect between two buildings or at a corner). \\ In this case, have a look at the output (if available) and consider to vary the model configuration a little bit at the suspicious corners. \\ In this case, have a look at the output (if available) and consider to vary the model configuration a little bit at the suspicious corners. \\