Sources Database SOURCES.DAT

Related Stuff: Additional local databases (.CF file)

Introduction

ENVI-met allows to simulate the release and dispersion of gases and particles. To used this option, you must add Sources to the Area Input File.
At the moment, all sources in the model must be of the same type, e.g. they all have to be S02 sources. You cannot have for example one SO2 source and a NOx source in the model at the same time.

Due to the significant amount of information needed to place sources in the model, the information about the sources is stored in three different locations:

So basically, the concept is the same as for plants and soils: a two-char ID is placed in the in the Area Input File and a number of databases is used to define how this ID behaves. However, the separation between the emission rate and the definition of the type of source is a bit artificial. This might be changed in later versions.

Information stored in SOURCES.DAT and optional local database

The database file contains information about:

  • The type of source (point, line or area source)
  • The height of release
  • The emission rates in 24 values for each hour of the day

This is an example for a SOURCES.DAT file:

 
01: ----- Sources-Database. Type (T) 1,4=point, 2,5=line 3,6=area, E in mg/s (1), mg/s*m (2) or mg/s*m² (3), µg/s (4), µg/s*m (5) or µg/s*m² (6)
02: ID T hh.hh E(00h) E(01h) ... E(23h) Name (40)
03: xx 5  0.30 010.00 010.00 ... 010.00 Test_Pointsource 10m,10mg/s

What do the lines and columns mean?

The first two lines are headers to indicate the position of the different data entries.

The meaning of the columns is:

ID:        the two-digit ID which links the sources data to the Area Input file.
           ENVI-met uses non-case sensitive IDs, "xx" is the same as "XX"

T:         Type of source and information, in which unit the emission data is stored
           Possible types are           Point source (T=1) in mg/s, 
                                        Line Source (2) in mg/(s*m) and 
                                        Area Source (3) in mg/(s*m²)
           If the emission data is given in µg/.. instead of mg/... use types 4,5 and 6 respectively

hh.hh:     Height of source in m. (Will be adjusted to grid mesh by ENVI-met)

E(00h)     Emission rate at 00.00,

E(01h)     Emission rate at 01.00

... and so on until....

E(23)      Emission rate at 23.10 (links to the Emission rate at 00.00 for interpolation)

Name       Given name for source (up to 40 chars)

The data for the emission rates is dynamically adjusted during the simulation according to the hour of simulation (linear interpolation).

This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies